SNS Series Hydraulic Bolt Cutter: Powerful Cutting Made Easy
I. Introduction
A hydraulic bolt cutter is a tool designed for cutting bolts, chains, and other tough materials using hydraulic power.
It is commonly used in industrial and construction settings requiring heavy-duty cutting.
The tool operates by using hydraulic pressure to generate a force that is applied to the cutting blades.
This hydraulic force allows the cutter to easily slice through strong materials with minimal effort from the user.
SNS Series Hydraulic Bolt Cutter
Features:
-Capacity: 103 - 193ton
-Bolt Range: M45 - M90
-Maximum Operating Pressure: 700bar
-Optional Pumps: SPS Series Manual Pump, PE4 Small Electric Pump, and PA4 Small air hydraulic pump.
-Uniquely designed to suit standard ANSI B16.5/ BS1560 flanges.
-Single-acting, spring return cylinder.
II.How SNS Series Hydraulic Bolt Cutters Work
SNS Series Hydraulic Bolt Cutters use a Hydraulic System to apply force to a cutting blade.
The hydraulic system is powered by a pump, which is typically powered by an electric motor or air compressor.
The pump pressurizes fluid, which is then routed to the cutting blade.
The pressurized fluid forces the cutting blade to move, cutting through the bolt or fastener.
III.How to Maintain SNS Series Hydraulic Bolt Cutter
Proper maintenance is key to extending the lifespan of the SNS Series Hydraulic Bolt Cutter.
Follow these guidelines to ensure optimal performance:
a)Regular Inspection:
Check for any visible signs of wear, damage, or fluid leaks.
Inspect hydraulic hoses for integrity and tight connections.
Verify that the cutting blades are sharp and in good condition.
b)Lubrication:
Keep all moving parts well-lubricated to reduce friction and prevent premature wear.
Use the recommended lubricants as specified in the user manual.
c)Hydraulic Fluid:
Monitor hydraulic fluid levels and quality regularly.
Follow the manufacturer's recommendations for hydraulic fluid replacement intervals.
d)Cleaning:
Remove debris and contaminants from the tool after each use.
Wipe down the external surfaces to prevent the accumulation of dirt and grime.
e)Calibration:
Periodically check and calibrate the cutting force to ensure accurate and consistent performance.
IV.SNS Series Hydraulic Bolt Cutter:FAQs
Q: How often should I check the hydraulic fluid level?
A: The hydraulic fluid level should be checked every time the cutter is used. If the fluid level is low, add fluid until it reaches the full mark on the sight glass.
Q: How often should I inspect the cutting blades?
A: The cutting blades should be inspected for wear or damage every time the cutter is used. If the blades are worn or damaged, they should be replaced
immediately.
Q: How often should I lubricate the cutter?
A: The cutter should be lubricated every 25 hours of use. Use high-quality hydraulic oil or grease.
Q: How often should I inspect the hoses and fittings?
A: The hoses and fittings should be inspected for leaks and damage every 50 hours of use. If any leaks or damage are found, the hoses or fittings should be
replaced immediately.
Q: How often should I clean the cutter?
A: The cutter should be cleaned after each use to remove dirt and debris. Use a mild detergent and water solution.
Q:What if there is a problem with the purchased product?
A:If any quality problem happens please take some photos and videos to show the exact problem, then our engineer will judge and give a solution.
